Tuesday, January 12, 2010

Western Ceramic Tile I Have A Building In Which I Have To Remove Apx. 10,000 Sq. Ft. Of Ceramic Floor Tile, How Much Should I Pay?

I have a building in which i have to remove apx. 10,000 sq. ft. of ceramic floor tile, how much should i pay? - western ceramic tile

What is the approximate price per square meter ft.i should expect to pay to have it removed in the AP-west.

2 comments:

Tedruski said...

Much depends on the configuration of the rooms. If everything is a large open area * (was) probably not, I would say 75 to $ 1.00 per square foot. The large of an area with a high ceiling, I had a little demo with wild cats and a bucket of sharp edges.
Remember, the funeral set for many tiles. The pottery is heavy for the garbage can not be filled to the brim.
Cut for small areas, the contractors may have a hammer to use Jack, but it is slow. Then, to be used after the brick-cement grinding plant for the mortar, while under the tile.
I'd like to get (3) provides that to be considered. Do you have exactly what you want and make sure it is listed in their proposals.
They are talking with each contractor to tender for this work and questions. Make sure your employees are covered under the policy of insurance against accidents Workmen. Please note also specify which conditions you want the concrete slab after they are done. If you want all the old liquid mortar withdrawal state. If you really want soft ground has a specific griNder said.
Compare instincts 3 and is estimated to do the job. "
Like I said - you get everything in writing.
Good Luck

ladyrulz said...

Normally paid to rip at least as much as the installation cost (from $ 2.50 to $ 3.50 per s / w, depending on where you live) plus dump fees. Most installation programs require more preparation for a new ground. I think it's on the plate, which are thoroughly cleaned in order to install new tiles. Some installers, even in car air conditioners scissors, etc. to help eliminate. Further work is needed to reduce tiles by () very intense.

Post a Comment